Titan tankless water heaters heat water only when you need it.  So you save money and reduce waste by not heating and reheating the same tank of water.

When there is a demand for hot water, the Titan tankless water radiator unit senses the flow and starts the heating process.  This results in hot water that is not limited to what’s available in your tank, so you always have clean, hot water when you want it for as long as you need it!  When the demand for hot water ceases, the tankless unit shuts down and uses no energy.

Titan tankless water heaters save you up to 60% off your water heating costs, allowing you to do away with that huge and bulky conventional tank water radiator that has to be replaced every 12 years, on average.

Being about the size of a Yellow Pages buzz book, Titan tankless water heaters save space and can be installed nearly anywhere inside your home. Generally the units are installed where your ancient tank radiator used to be. You only need a minimum of 12 inches of clearance from the top of the Titan tankless unit to the ceiling, so imagine the space that you will be saving!

These water heaters can be used with PVC, PVX or other similar pipes and you just need to use 36 inches of copper piping at the inlet and outlet to act as a buffer between the Titan and your plastic tubing.

The Titan tankless water heaters are extremely resistant to hard water as the heating elements are housed inside very rugged copper and brass chambers. The Titans also work with well water systems because they are calculated to run in the range of between 5 and 21 PSI.

The Titan tankless water heaters not only save you space and money, but they are healthier too. Bacteria, rust and sediment accumulates in a standard tank model. By replacing your bulky conventional tank water radiator, the water is heated only once with the Titans. Have you ever seen the sediment and rust that sits at the bottom of your standard tank radiator after just two years of use? It is shocking to see, plus bacteria can thrive in the temperatures that are maintained in the ancient tank heaters.

Be sure to check the wiring needs before installation.  A 60 amp benefit and number six wire are usually required.  This unit produces very quick hot water and mounts quickly to any wall.

With Titan water heaters, when you turn on the hot water faucet a sensor turns on the heating elements/heat exchanger and a computer chip selects the right power based on the heat setting and flow rate you select. The water flows across the internal heating elements and comes out of the faucet at the warmth you selected. This start-up process only takes a couple of seconds. Then as soon as you turn off the faucet, the unit turns off completely, saving you money and eliminating stand-by heating loss.

So if you are tired of in succession out of hot water, want to save a considerable amount of electricity and have hot water on demand that is fresh and reliable, Titan water heaters are the solution for you!